Ledger
Email this Article

Removing Stucco Siding For The Ledger Board

Generally, ledger boards cannot be installed directly over traditional stucco, synthetic stucco or cultured stone exterior cladding.  Stucco is easy to cut through but can be somewhat fragile. Take a couple minutes to inspect the area where you will be cutting. If you notice any cracks or deterioration in the stucco you should realize that the vibrations caused by cutting will probably cause further damage. You will need a circular saw with a diamond blade and a cold chisel. Once you have drawn the outline of your ledger board on the stucco you can cut through the stucco and the metal screed it uses to grip to the house. Be careful not to cut too deep and concentrate on cutting a straight clean line.  Once the connection is made make sure you flash the cladding above, below and to both sides of the opening.

Care must be given to not damage or tear the water-resistive membrane behind. A weepscreed must be installed and laced behind the water-resistive membrane and typically a piece of self-adhering, polymer-modified bitumen is installed as well to seal the membrane at the weepscreed. Flashing must also be installed over the ledger in a similar manner. The weepscreed should be held approximately one to two inches above the finished surface of the deck to allow clearance for drainage and drying behind the cladding. 

Sponsors

Comments, Questions and Reviews

POST A NEW COMMENT

My house from the 50’s, so it probably doesn''t have a waterproof membrane behind the stucco. The area I’m cutting through also has a large (30” eve) overhanging the wall. How concerned do I need to be about moisture penetration? How can I seal up the bottom of this stucco, and not have something ugly showing at the base of the wall when I am finished? Can you show a diagram of how to install flashing or whatever is needed at the base of the cut?

posted by ABM85 at 4/17/2015 4:15:21 PM